 |
 |
 |
|
|
|
[Sponsors] | ||||
November 29, 2011, 15:41
|
gmsh -> OpenFOAM = noise?
|
#1 |
|
New Member
Hsingtzu Wu
Join Date: Feb 2011
Posts: 24
Rep Power: 15  |
Hi
I made a mesh with gmsh and imported it to OpenFOAM using gmshToFoam. It worked, but there seemed some noise around the model in OpenFOAM. I attached the model, and you can clearly see there was some noise inside of the cylinder hole where I set boundary conditions. I was wondering if anyone encountered the issue and knew how to resolve it. Thanks |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Gmsh] Converting gmsh to OpenFoam | Friendly | OpenFOAM Meshing & Mesh Conversion | 3 | June 26, 2018 05:46 |
| OpenFOAM Training Jan-Jul 2017, Virtual, London, Houston, Berlin | CFDFoundation | OpenFOAM Announcements from Other Sources | 0 | January 4, 2017 06:15 |
| OpenFOAM v3.0+ ?? | SBusch | OpenFOAM | 22 | December 26, 2016 14:24 |
| OpenFOAM Training: Programming CFD Course 12-13 and 19-20 April 2016 | cfd.direct | OpenFOAM Announcements from Other Sources | 0 | January 14, 2016 10:19 |
| gmsh to openfoam | sarajags_89 | OpenFOAM | 1 | October 8, 2009 05:15 |
Linear Mode
