using mergeMeshes and stitchMesh
I have created two very simple cases consisting of a cube and a cylinder. I have successfully blockmeshed them but I am struggling with joining the cases together.
Actually, I had managed it once and even noted what I did, but apparently I must have missed something as I have not been capable of repeating the whole action and get the joint case running. Could anyone give me a hint and/or write here the right procedure, please? |
Quote:
I've written up the procedure in this thread: http://www.cfd-online.com/Forums/ope...hes-p-t-u.html Hope it helps! Tomislav |
That was it. Thank you Tomislav.
Lada |
All times are GMT -4. The time now is 17:26. |