|
[Sponsors] |
April 9, 2012, 01:53 |
spline or simpleSpline ?
|
#1 |
New Member
Nicholas Yue
Join Date: Mar 2012
Posts: 5
Rep Power: 14 |
Hi,
I am new to OpenFOAM. The current documentation (PDF) for OpenFOAM 2.1 talked about various edge types arc simpleSpline polyLine polySpline line But calling the blockMesh executable with a simpleSpline edge type resulted in the following errors --> FOAM FATAL ERROR: Unknown curvedEdge type simpleSpline Valid curvedEdge types are 4 ( arc line polyLine spline ) Is there a more updated documentation about spline in meshing for OpenFOAM ? Regards |
|
November 22, 2012, 12:05 |
|
#2 |
New Member
Dave Crossley
Join Date: Oct 2010
Posts: 18
Rep Power: 15 |
Hi All,
I realise this post is a little old but I am also having the same problem. I am using openFOAM v2.1.1 and only the polyLine and spline is working but both are very jagged in there interpolation between points. I am hoping that simpleSpline will give me a better result but I am getting a 'Unknown curvedEdge' error. My blockMeshDict is working with no errors when I change to a standard polyLine curve. Any help would be welcome. P.S. I was thinking it maybe a bug or installation error as when OF gives me a list of acceptable curve commands simpleSpline is not their. It is as though I am running from a much older version of OF. |
|
July 18, 2013, 16:21 |
Bug
|
#3 |
New Member
Amadeo Moran
Join Date: Jan 2012
Location: Madrid
Posts: 10
Rep Power: 14 |
Hi,
I have the same problem with OpenFOAM 2.2.0. At version 1.6 was a Bug like it and here is the solution: http://repo.or.cz/w/OpenFOAM-1.6.x.g...17616acf499689 I tried to do it but does't work for me because I'm running on mac and I should recompile the program, but you can try, maybe it's work for you! Regards Amadeo |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
airfoil edge via spline in OpenFOAM v6 | jkampman | Mesh Generation & Pre-Processing | 0 | November 26, 2018 05:19 |
[DesignModeler] spline or bezier or B spline | panasonic | ANSYS Meshing & Geometry | 0 | February 4, 2017 00:19 |
Spline in DesignModeler? | Edu-R | ANSYS Meshing & Geometry | 1 | April 4, 2010 18:04 |
[blockMesh] BlockMesh problem | pratap | OpenFOAM Meshing & Mesh Conversion | 21 | February 16, 2009 06:32 |
OpenFOAM book | betakv | OpenFOAM | 5 | January 13, 2009 07:06 |