OpenFOAM® training - Advanced physical modeling capabilites. February 17-21, 2020.
 

OpenFOAM® training - Advanced physical modeling capabilites.

February 17-21, 2020. University of Genoa, Italy - WolfDynamics.

https://bit.ly/2WQP0bu




We want to draw your attention to the upcoming OpenFOAM® advanced training session that will take place in February 17-21, 2020. During this classroom training session we will address the following topics:

• February 17, 2020 - Turbulence modeling in general CFD and OpenFOAM® - Theory and applications

• February 18, 2020 - Multi-phase flows modeling in general CFD and OpenFOAM® - Theory and applications

• February 19, 2020 - Moving meshes, rigid body motion, adaptive mesh refinement, and overset meshes in OpenFOAM®.

• February 20, 2020 - Introduction to the FVM method, discretization techniques, and solution strategies. Standard practices in general CFD with applications to OpenFOAM®.

• February 21, 2020 - Open day (free for participants of the advanced training). This day (from 9:30 to 16:00), is dedicated to help participants to setup their cases.

So hurry up and book your place, you are still on time to take advantage of ours reduced fees.

You can find more information in the following link: https://bit.ly/2WQP0bu

Prerequisites: intermediate knowledge of CFD, OpenFOAM®, and Linux is required. Some basic knowledge of C++ and shell scripting is beneficial.

Location: DICCA, University of Genoa. Via Montallegro 1, 16145 Genoa, Italy.

Course times: from 9:00 am to 5:00 pm, plus 30 minutes of Q&A.

Language: English

Number of seats: 15 places available.

Training material: every participant will get a copy of the printed lecture notes (high quality color), and an USB key with the supporting material.

Teaching method: lectures and hands-on sessions to validate the acquired knowledge.

Additional information:

• These courses are offered in cooperation with the University of Genova.
• The fee includes the printed material (high quality color), an USB key with the supporting material, and lunch and refreshments.
• Attendees are not required to bring their own laptop since workstations with pre-installed software will be available.
• A training certificate is provided to all attendees who complete the course.