OpenFOAM advanced training. July 27-31, 2020
 

OpenFOAM advanced training. July 27-31, 2020 (https://bit.ly/2Mv5IsR)

We want to draw your attention to the upcoming OpenFOAM advanced training session that will take place in July 27-31, 2020. During this classroom training session we will address the following topics:

• July 27, 2020 - Introduction to solid modeling for general CFD and meshing using OpenFOAM technology - Onshape and snappyHexMesh.

• July 28, 2020 - Design of experiments, space exploration, knowledge extraction, and numerical optimization using Dakota - Code coupling Dakota-OpenFOAM.

• July 29, 2020 - Turbulence modeling in general CFD and OpenFOAM - Theory and applications.

• July 30, 2020 - Introduction to the FVM method. Standard practices in general CFD with applications to OpenFOAM.

• July 31, 2020 - Open day (free for participants of the advanced training). This day (from 9:30 to 16:00), is dedicated to helping participants to setup their cases. Note: Lunch is not included.

So hurry up and book your place, you are still on time to take advantage of ours reduced fees.

You can find more information in the following link: https://bit.ly/2Mv5IsR




Prerequisites: intermediate knowledge of CFD, OpenFOAM, and Linux is required. Some basic knowledge of C++ and shell scripting is beneficial.

Location: DICCA, University of Genova, (via Montallegro 1, 16145 Genova, Italy).

Course times: from 9:00 am to 5:00 pm, plus 30 minutes of Q&A.

Language: English

Number of seats: 15 places available.

Training material: every participant will get a copy of the printed lecture notes (high quality color), and a USB key with the supporting material.

Teaching method: lectures and hands-on sessions to validate the acquired knowledge. A training certificate is provided to all attendees who complete the course.

Additional information:

These courses are offered in cooperation with the University of Genova.

The fee includes the printed material (high quality color), a USB key with the supporting material, and lunch and refreshments.

Attendees are not required to bring their own laptop since workstations with pre-installed software will be available.