|September 24, 2012, 11:36||
export STL from ParaView issues
Join Date: May 2010
Location: Lund, Skåne, Sweden
Posts: 143Rep Power: 8
Maybe I am using an old version of paraview but I dont think it should matter.
Im trying to extract a surface from a given mesh into .STL but the output is just horrible.
I added a picture of the liner, loooks messed up.
Did anyone encounter this before?
|September 24, 2012, 11:54||
Join Date: Mar 2009
Location: Lisbon, Portugal
Blog Entries: 39Rep Power: 104
Apply the filter "Triangulate" before exporting.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Fluent 6.3 export to Paraview 3.10||Silence19||FLUENT||4||May 15, 2013 03:13|
|Some Paraview Issues I can not solve||MR_Chicho||ParaView||1||September 24, 2012 05:03|
|ParaView 3.6.1 & 3.7.0: Can't view STL files||johannes||OpenFOAM Paraview & paraFoam||2||December 3, 2009 15:07|
|paraFoam reader for OpenFOAM 1.6||smart||OpenFOAM Installation||13||November 16, 2009 22:41|
|OpenFOAM on MinGW crosscompiler hosted on Linux||allenzhao||OpenFOAM Installation||127||January 30, 2009 20:08|