CFD Online Discussion Forums

CFD Online Discussion Forums (
-   OpenFOAM Paraview & paraFoam (
-   -   touch cavityFine/cavityFine.OpenFOAM PROBLEM! (

Amir1 May 30, 2013 18:07

touch cavityFine/cavityFine.OpenFOAM PROBLEM!
Hi guys,

I m trying to run the cavityFine on paraFoam based on the cavity problem in the user manual.

I did make the cavityFine file and I did the mapFields. Now I want to open up two files (cavity and cavityFine) with paraView but typing the following commamnd doesnt do anything:

touch cavityFine/cavityFine.OpenFOAM

Any suggestions or comments?

wyldckat June 8, 2013 16:17

Greetings Amir,

If the command does not give you any errors, then it worked with success. You can check if the file was created by running:

ls -l cavityFine/cavityFine.OpenFOAM
If it shows you that the file does exist, then open it in the ParaView window you already have open from the first "cavity" case.

Best regards,

Amir1 June 8, 2013 22:01

Thanks so much.
I will try do check it out and will let you know.


All times are GMT -4. The time now is 06:23.