|
[Sponsors] |
[OpenFOAM] Difference in magnitude in color bar and plot |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 3, 2013, 08:07 |
Difference in magnitude in color bar and plot
|
#1 |
Member
vishal
Join Date: Mar 2013
Posts: 73
Rep Power: 13 |
The maximum magnitude in the color bar and the in the plot are showing different.Unable to understand why?.I have attached the plot and the magnitude bar.Please tell, how to sort this problem.
Thanks in advance |
|
July 7, 2013, 06:15 |
|
#2 |
Retired Super Moderator
Bruno Santos
Join Date: Mar 2009
Location: Lisbon, Portugal
Posts: 10,975
Blog Entries: 45
Rep Power: 128 |
Greetings Vishal,
You're not providing much information about this, so all I can do is guess My guess is that your line plot is showing values inside the volume, while on the 3D image you're seeing the surface. And if the case is not 2D, then it's very likely that the values on the surface are much higher than inside the volume. Use the "Slice" filter in the same zone where you have got the line for the plot, so that you can properly compare the results. Best regards, Bruno
__________________
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[OpenFOAM] Plot over line average magnitude of particle velocity in paraview | maysmech | ParaView | 13 | August 12, 2022 11:46 |
contour plot: mass flow difference | jai | CFX | 3 | December 16, 2017 06:20 |
difference plot: turbulent kinetic energy (URANS) vs. Reynolds Stresses (LES) | fabfi | CFX | 2 | November 21, 2017 10:29 |
plot along a circle | pcn90 | FLUENT | 2 | May 7, 2017 06:41 |
[swak4Foam] Foam warnings - related to swak4Foam | Salam-H | OpenFOAM Community Contributions | 20 | August 2, 2015 15:40 |