CFD Online Discussion Forums

CFD Online Discussion Forums (
-   OpenFOAM Paraview & paraFoam (
-   -   show the interface between different processors (

openfoammaofnepo August 19, 2013 05:54

show the interface between different processors
Hi All,

I finished a parallel case using openfoam, and then open the results using paraview. The case type I choose is reconstructed case. My question is how I can make the processor interface shown in paraview? I would like to see how the geometry is partitioned. Does anybody know how to implement this?

Thank you very much.

Bernhard August 19, 2013 06:35

You can create the .foam files in the processor directories and open these. You'll be able to than treat the interface between processors as you normally treat patches.

All times are GMT -4. The time now is 23:26.