|
[Sponsors] |
November 27, 2013, 01:17 |
Paraview problem
|
#1 |
New Member
CFDGuy
Join Date: Nov 2013
Posts: 5
Rep Power: 12 |
Hello All,
I have installed blueCFD, I can run the tutorial simulations and I know it works because I check different time steps and see the values for pressure and velocity. But when I run the Paraview it just shows an empty box where velocity and pressure is zero. Does anyone have any idea about this problem ? Thanks. |
|
November 27, 2013, 17:33 |
|
#2 | ||
Retired Super Moderator
Bruno Santos
Join Date: Mar 2009
Location: Lisbon, Portugal
Posts: 10,975
Blog Entries: 45
Rep Power: 128 |
Greetings Mehdi and welcome to the forum!
I'm assuming you've installed blueCFD-SingleCore, correct? This is a somewhat common problem with people that are trying out OpenFOAM and ParaView/paraFoam for the first time. I'll quote myself from a couple of years ago: Quote:
Bruno
__________________
|
|||
December 1, 2013, 03:43 |
|
#3 |
New Member
CFDGuy
Join Date: Nov 2013
Posts: 5
Rep Power: 12 |
Thanks Bruno, it helps. It works as you said.
Best regards |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ParaView Execute problem | insta | OpenFOAM Installation | 2 | June 9, 2014 02:37 |
[General] Problem in using paraview | meballav | ParaView | 11 | October 12, 2012 16:03 |
[OpenFOAM] Installation problem with ParaView 3.8.0 on openSUSE 11.2 | aero_ | ParaView | 14 | August 2, 2010 18:13 |
Yet another Paraview problem | gascortado | OpenFOAM | 5 | February 21, 2010 06:39 |
[OpenFOAM] Problem with Colors in ParaView | sven | ParaView | 1 | May 31, 2009 08:13 |