[OpenFOAM] specific filter in paraview

sanjar · January 20, 2014, 11:19

hey guys,

i am looking for a filter which could describe my velocity of my fluid (water) on a imaginary line for for example) 40 points on this line.
these 40 points should create at the end a graph with x-and y axis which shows the behaviour of my velocity at every single point.

i hope the attached picture helps you to understand what i mean.

is there such a filter in paraview? if not, is there an alternative to describe it in a smiliar way? unfortuanatley i did not find anything in paraview so far.

thank you guys

alexeym · January 20, 2014, 11:39

Hi,

The picture you've provided corresponds to 'Plot over line' filter.

sanjar · January 20, 2014, 11:53

hey this function was deactivated when i tried this based on research on the internet.After i updated paraview it worked.

Thank you very much at all. This is what i was looking for!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Setting the height of the stream in the free channel	kevinmccartin	CFX	12	October 13, 2022 21:43
Simulation of a single bubble with a VOF-method	Suzzn	CFX	21	January 29, 2018 00:58
Compression stoke is giving higher pressure than calculated	nickjuana	CFX	62	May 19, 2015 13:32
error message	cuteapathy	CFX	14	March 20, 2012 06:45
Newbie: Install ParaView 3.81 on OF-1.6-ext/OpenSuse 11.2?	lentschi	OpenFOAM Installation	1	March 9, 2011 02:32

January 20, 2014, 11:39		#2
alexeym Senior Member Alexey Matveichev Join Date: Aug 2011 Location: Nancy, France Posts: 1,930 Rep Power: 38	Hi, The picture you've provided corresponds to 'Plot over line' filter.

January 20, 2014, 11:53		#3
sanjar Member ziehjay Join Date: Jul 2013 Posts: 45 Rep Power: 12	hey this function was deactivated when i tried this based on research on the internet.After i updated paraview it worked. Thank you very much at all. This is what i was looking for!