[General] Surface Rendering Problem

TinaB · March 12, 2015, 05:59

Dear Community,

I made a simulation using OpenFOAM, which I am now post-processing in ParaView 4.1 on Windows (pre-compiled binaries).

When I am displaying walls in my geometry (please note that this is a multi-region case) the surface rendering shows weird effects (lines crossing from one part of the surface to another, see attached screenshot) which change when I rotate the geometry in the graphics window.

I've been using ParaView for quite some time now, but I've never seen this behaviour before.

Does anyone know how to cure this problem?

TinaB · May 20, 2015, 10:51

The solution was to update my Nvidia graphics card driver. Everything displays beautifully now.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] surface mesh merging problem	everest	ANSYS Meshing & Geometry	44	April 14, 2016 06:41
Cluster ID's not contiguous in compute-nodes domain. ???	Shogan	FLUENT	1	May 28, 2014 15:03
free surface problem with capillary effect	rabbitmelon	CFX	25	August 16, 2013 03:05
[Gmsh] boundaries with gmshToFoam‏	ouafa	OpenFOAM Meshing & Mesh Conversion	7	May 21, 2010 12:43
surface orentation problem in icemcfd	jeevan kumar	CFX	0	August 18, 2008 04:25

May 20, 2015, 10:51		#2
TinaB New Member Martina Blank Join Date: Feb 2014 Posts: 8 Rep Power: 12	The solution was to update my Nvidia graphics card driver. Everything displays beautifully now.