[General] Export STL from iso-surface

changhee.kim · September 21, 2016, 07:41

I'm using ParaView 5.1.2.

I'm trying to export a iso-surface or threshold from a result into *.stl file.

I add a figure below.

Best regards,

Changhee Kim

Phil_ · September 21, 2016, 08:10

Hey, that's how I usually do it:

Iso-surface:

Iso-Surface filter
Triangulate filter
File -> SaveData: Type 'Stereo Lithography File Format (*.stl)'

Threshold:

Threshold filter
Extract Surface filter
Triangulate filter
File -> SaveData: Type 'Stereo Lithography File Format (*.stl)'

Best
Phil

changhee.kim · September 21, 2016, 20:18

Thank you so much!!

FC1079 · February 9, 2017, 16:28

I am new to tecplot. I don't know how to get this isosurface filter/ triangulate filter option. Is there a dropdown box I am missing?

September 21, 2016, 08:10		#2
Phil_ Member Join Date: May 2014 Posts: 40 Rep Power: 11	Hey, that's how I usually do it: Iso-surface: Iso-Surface filter Triangulate filter File -> SaveData: Type 'Stereo Lithography File Format (.stl)' Threshold: Threshold filter Extract Surface filter Triangulate filter File -> SaveData: Type 'Stereo Lithography File Format (.stl)' Best Phil arvindpj and K.Lau like this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] snappyHexMesh cannot achieve smooth surface from stl	alex::cfd	OpenFOAM Meshing & Mesh Conversion	2	October 22, 2018 12:39
[mesh manipulation] extrudeMesh from STL Surface	TRT	OpenFOAM Meshing & Mesh Conversion	1	March 26, 2018 07:15
[snappyHexMesh] Snap Precision to a STL Surface	malaboss	OpenFOAM Meshing & Mesh Conversion	16	July 26, 2013 01:44
[Workbench] Meshing and export mesh from STL geometry	alerfreire	ANSYS Meshing & Geometry	0	March 26, 2013 09:25
[Gmsh] boundaries with gmshToFoam‏	ouafa	OpenFOAM Meshing & Mesh Conversion	7	May 21, 2010 12:43

September 21, 2016, 20:18		#3
changhee.kim New Member changhee kim Join Date: Feb 2014 Posts: 18 Rep Power: 12	Thank you so much!!

February 9, 2017, 16:28		#4
FC1079 New Member FC Join Date: Feb 2017 Posts: 1 Rep Power: 0	I am new to tecplot. I don't know how to get this isosurface filter/ triangulate filter option. Is there a dropdown box I am missing?