|
[Sponsors] |
December 12, 2007, 08:29 |
How to saveexport the actual view
|
#1 |
New Member
Nils Langer
Join Date: Mar 2009
Location: Germany
Posts: 1
Rep Power: 0 |
Hi
I like to save only the geometry, that is shown (parafoam) in the moment I'm saving. Saving after a threshold for example still includes all information, though I want the seen faces/points only; in order to work furtheron with this data. Best would be, if I could get an output file in ascii. Does it work properly if I change 'binary' to 'ascii' in the /system/controlDict file? Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rotate blade to blade view for cfdpost report | Lada | CFX | 1 | November 29, 2018 05:16 |
[General] command to modify 3D View size? | macfly | ParaView | 0 | April 9, 2014 00:31 |
SW Isometric view in paraFoam | Nikunj.R | OpenFOAM Post-Processing | 0 | December 3, 2012 15:34 |
Fluent - View Factor for s2s radiation | Markus | FLUENT | 1 | October 16, 2005 01:33 |
view rotation in provis | Anna (aka new-user) | Siemens | 3 | November 19, 2004 08:45 |