|April 20, 2007, 14:31||
Hi I would like to know, wh
I would like to know, why in my new case and also case (Tutorials) such as, cavity and PitzDaily always the same view in Display the Geometrie axes (cube axes in paraview). I mind hier that somehow the Measurements aren't correct.
For Example. I write in my BlockMeshDict
(2 1 0.5) --> if I zoom the view in Paraview and I click the cube axes , then it must be (2.2 1.2 0.7). Something does't right , every vertices without command +0.2m.
Actually I haven't realized before, till my supervisor asked to find out about this. Actually before I sent this Thread. I have already looked out in Paraview Documentation and user Guide, but I cannot found it.
If anybody knows, please tell me.
|April 23, 2007, 12:29||
The values on the paraview axi
Join Date: Mar 2009
Posts: 3,987Rep Power: 41
The values on the paraview axis only give you a hint of the size (the exact values sometimes event vary when you rotate the geometry). The real extent of the geometry can be found
* in polyMesh/points (a bit hardcore, but this is the only truth)
* by using the values checkMesh gives you
* if you want to use paraview(Foam): go to the Information-tab of the imported geometry. There is a section Bounds at the bottom. These are the values paraview sees (should be the same OpenFoam sees)
Note: I don't use "Friend"-feature on this forum out of principle. Ah. And by the way: I'm not on Facebook either. So don't be offended if I don't accept your invitation/friend request
|Thread||Thread Starter||Forum||Replies||Last Post|
|Gambit help: Cube inside cube||Jack Martinez||FLUENT||13||August 11, 2010 06:29|
|axes||Arj||CFX||2||March 19, 2009 07:27|
|chansfer of axes||mao||FLUENT||0||August 30, 2006 20:36|
|Global & Local axes||azmir||CD-adapco||1||August 4, 2003 20:51|
|Two rotating axes ?||Michael Palm||Main CFD Forum||1||September 1, 1999 07:59|