[OpenFOAM] ParaView problem with Regions -- CFD Online Discussion Forums

September 14, 2006, 07:12	ParaView problem with Regions	#1
lr103476 Senior Member Frank Bos Join Date: Mar 2009 Location: The Netherlands Posts: 340 Rep Power: 18	Hi, I recently installed the latest precompiled OpenFOAM v1.3 and the latest precompiled ParaView v2.4.4. ParaFoam starts correctly and I can visualise the flow nicely, using All Regions On. When I switch off the Internal Mesh region to visualise (for example) the mesh on some other regions (wall boundaries in my case) a blank screen is shown. Could this be caused by the parafoam reader? Regards, Frank __________________ Frank Bos

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[OpenFOAM] Paraview 3.98.0 does not update list of mesh regions	letzel	ParaView	6	April 19, 2021 15:57
[General] Problem opening paraview (remote)	alexvaleije	ParaView	0	June 23, 2016 12:03
[OpenFOAM] Problem switching from terminal to paraView	Maxime Thomas	ParaView	10	October 4, 2014 10:59
Yet another Paraview problem	gascortado	OpenFOAM	5	February 21, 2010 06:39
Problem with Paraview graphics	Ronnfors	OpenFOAM	8	November 4, 2009 12:49

All times are GMT -4. The time now is 03:25.