|
[Sponsors] |
September 7, 2009, 02:55 |
ParaView Illustration
|
#1 |
Member
|
Hi,
I'm a french student in a german company. I'm alone in my company to use OpenFoam. I have OpanFOAM 1.6 and 1.5 but now I try just of the 1.6 version. From a ProEngeener-files, I generate a tetrahedral mesh with StarCCM+, then I convert this mesh in .ccm with the same software. Thank to the ccm26ToFoam command, I convert the .cmm-file. After that or after the calculation, I start paraView to see my part but I see just a square (in 2d like a pattern but it's not the cylinder), whereas i should see a cylinder. The illustration works on OF 1.5 but doesn't work on the 1.6. With a part in a parallepiped geometry, it works always (OF 1.5 and 1.6). What is my problem ? Thank you Simon Last edited by sheintz; September 7, 2009 at 09:49. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[OpenFOAM.org] Paraview 5.4 in shell environment of5x - Segmentation fault (core dumped) | dslbkxd | OpenFOAM Installation | 1 | February 3, 2018 00:56 |
[OpenFOAM.org] Two different versions of ParaView with same OpenFOAM release | FJSJ | OpenFOAM Installation | 2 | July 23, 2017 05:48 |
Installing OpenFOAM and ParaView in VirtualBox(Ubuntu on Win8) | chrisb2244 | OpenFOAM Installation | 2 | August 21, 2013 13:24 |
Newbie: Install ParaView 3.81 on OF-1.6-ext/OpenSuse 11.2? | lentschi | OpenFOAM Installation | 1 | March 9, 2011 02:32 |
paraFoam reader for OpenFOAM 1.6 | smart | OpenFOAM Installation | 13 | November 16, 2009 21:41 |