Segmentation fault with paraFoam and paraview 3.6.1 on Fedora 11 32 and 64 bit
 

Hello Foamers,

I installed OpenFOAM 1.6, and I ran a 8 core parallel case using the LES model.


I found some difference between 1.5 and 1.6, but the simulation is good, with good result.


Problems come with paraFoam and paraview: trying to run them gives:


/home/test/OpenFOAM/ThirdParty-1.6/paraview-3.6.1/platforms/linux64Gcc/bin/paraview-real: error while loading shared libraries: libssl.so.0.9.8: cannot open shared object file: No such file or directory


I couldn't find the package providing this library and I tried to solve this problem with:


ln -s /usr/lib64/libssl.so.0.9.8k /usr/lib64/libssl.so.0.9.8



At this point parafoam and paraview gave the error:


Segmentation fault


I tried paraFoam and paraview 3.6.1 32 and 64 bit on Fedora 11 32 and 64 bit with the same result.


Any ideas??


Thanks

Try recompile paraview.It may help.

Thanks for tip but the problem remains after the compilation of paraview, here are the steps I followed in the compilation:

1) download the file ftp://ftp.trolltech.com/qt/source/qt...-4.3.5.tar.bz2 in to $WM_THIRD_PARTY_DIR

2) decompress it (tar -xjf qt-x11-opensource-src-4.3.5.tar.bz2)

3) compile Qt with
./makeQt | tee -a log_makeQt

4) when I tried to compile paraview with:

./makeParaView -qmake /home/optim/OpenFOAM/ThirdParty-1.6/qt-x11-opensource-src-4.3.5/bin/qmake > log_makeParaView 2>&1 &

I got:

cmake: /home/optim/OpenFOAM/ThirdParty-1.6/gcc-4.3.3/platforms/linux64/lib64/libstdc++.so.6: version `GLIBCXX_3.4.11' not found (required by cmake)

I tried to fix this problem with:

rm /home/optim/OpenFOAM/ThirdParty-1.6/gcc-4.3.3/platforms/linux64/lib64/libstdc++.so.6
ln -s /usr/lib64/libstdc++.so.6.0.12 /home/optim/OpenFOAM/ThirdParty-1.6/gcc-4.3.3/platforms/linux64/lib64/libstdc++.so.6

5) after these steps the compilation of paraview was done without error

very important things:
1) I installed cmake 2.6.4 with yum
2) after the compilation when I try to start paraview or paraFoam from local machine I get the GUI but non the functionality of 3D view
3) when I try to start paraview or paraFoam from remote machine with ssh -X I get Segmentation fault
4) same results with paraview 3.6.1 downloaded from www.paraview.org

Any ideas??