Home > Forums > Visualization & Post-Processing Software > ParaView

[OpenFOAM] Too small fonts in ParaView

Mark Forums Read

Reply

Search this Thread

October 8, 2009, 02:23	Too small fonts in ParaView	#1
jacek New Member Join Date: Oct 2009 Posts: 25 Rep Power: 16	How to enlarge fonts in ParaWiew? They are so small I can hardly see anything. Both solutions from http://www.paraview.org/pipermail/pa...er/006256.html don't work.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Error: Comparing the result of DTCHullWaves with two different ParaView version	ali.ikhsanul	OpenFOAM	0	December 11, 2017 05:17
[snappyHexMesh] .STL: non-closed manifold surface	giulio.topazio	OpenFOAM Meshing & Mesh Conversion	32	November 25, 2016 03:15
[General] Paraview launch & crash problems	dancfd	ParaView	3	January 17, 2013 12:04
[General] paraview ignores SPACING in STRUCTURED_POINTS vtk data?	jaffar	ParaView	0	November 27, 2012 09:36
paraFoam reader for OpenFOAM 1.6	smart	OpenFOAM Installation	13	November 16, 2009 21:41

All times are GMT -4. The time now is 17:23.