|April 25, 2012, 08:46||
calculate flow rate through a selected section? - paraview
Join Date: Mar 2009
Posts: 314Rep Power: 11
I completed a pimpleFoam case. I would like to calcuate flow rate through a "selected" cross-section in paraview. Is it possible?
In paraview, after I extracted the cross section I wanted, I tried to use the Calculator function. I saw the U vector, but, I do not see A so that I can do a U dot A to get flow rate.
Can someone point to me a dirction?
I am using OpenFOAM-2.1.x with paraview-3.12 on OpneSUSE 12.1.
|Thread||Thread Starter||Forum||Replies||Last Post|
|how to set BC for compressible flow target mass flow rate||foolboy007||FLUENT||1||April 4, 2012 03:24|
|Paraview fliter problem (surface flow) (segmentation fault)||maysmech||OpenFOAM||1||October 6, 2011 11:01|
|How to calculate the mass flow rate with UDF ?||HP||FLUENT||0||January 10, 2005 20:38|
|Target mass flow rate||Saturn||FLUENT||0||December 10, 2004 05:18|