U(0) U(1) U(2) U(magnitude)

Ahmed Khattab · June 8, 2012, 03:48

Hi Foamers,

do anyone know what these symbols mean in paraView?
it appears when i use plotOverLine you can choose between them in display window of object inspector.
i suggest it may be Ux,Uy,Uz . I'm right ??

kmooney · June 21, 2012, 15:48

Most likely, but it would be good to set up a simple case where you know the velocity components and verify them just to make sure. Depending on the paraview version you need to be really careful with tensor component naming conventions as well.

June 8, 2012, 03:48	U(0) U(1) U(2) U(magnitude)	#1
Ahmed Khattab Senior Member ahmed Join Date: Feb 2010 Posts: 182 Blog Entries: 1 Rep Power: 16	Hi Foamers, do anyone know what these symbols mean in paraView? it appears when i use plotOverLine you can choose between them in display window of object inspector. i suggest it may be Ux,Uy,Uz . I'm right ??

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

June 21, 2012, 15:48		#2
kmooney Senior Member Kyle Mooney Join Date: Jul 2009 Location: San Francisco, CA USA Posts: 323 Rep Power: 17	Most likely, but it would be good to set up a simple case where you know the velocity components and verify them just to make sure. Depending on the paraview version you need to be really careful with tensor component naming conventions as well.