|
[Sponsors] |
March 9, 2013, 04:32 |
High residuals in OF
|
#1 |
Member
AndreiCFD
Join Date: Nov 2012
Posts: 47
Rep Power: 13 |
`123`123`123`123
Last edited by andrei.cimpoeru; March 12, 2013 at 09:29. |
|
March 11, 2013, 19:12 |
|
#2 |
Member
|
From checkMesh:
************************************************** ***** Checking geometry... Overall domain bounding box (-10.000376 -10.007854 0) (11 10.007854 0.1) Mesh (non-empty, non-wedge) directions (1 1 0) Mesh (non-empty) directions (1 1 0) All edges aligned with or perpendicular to non-empty directions. Boundary openness (1.7765109e-18 -4.2555239e-18 -2.8634209e-15) OK. Max cell openness = 3.3056977e-16 OK. Max aspect ratio = 51.737546 OK. Minumum face area = 5.0707659e-06. Maximum face area = 0.023398855. Face area magnitudes OK. Min volume = 5.0707659e-07. Max volume = 0.0023398855. Total volume = 37.788576. Cell volumes OK. Mesh non-orthogonality Max: 65.31021 average: 5.4153154 Non-orthogonality check OK. Face pyramids OK. Max skewness = 1.8229301 OK. Coupled point location match (average 0) OK. Mesh OK. ************************************************** ***** Your mesh looks pretty good. What is your Reynolds number? Are you using orthogonal correctors in your fvSolution file? Your skewness is fairly low but you might still need them. Maybe post your boundary conditions as well, that could be the problem. -Nuc |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
SimpleFoam: High residuals after increase in Reynolds Number | JasonG | OpenFOAM Running, Solving & CFD | 21 | October 5, 2017 10:11 |
Extremely high residuals | Apocolapse | STAR-CCM+ | 0 | December 21, 2012 11:40 |
help high initial residuals | Aly | FLUENT | 0 | October 11, 2007 09:04 |
Help HIGH RESIDUALS | Aly | Fidelity CFD | 0 | October 11, 2007 08:57 |
Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 05:12 |