CFD Online Discussion Forums

CFD Online Discussion Forums (
-   OpenFOAM Post-Processing (
-   -   what do this outputed results indicate us? (

immortality May 5, 2013 08:01

what do this outputed results indicate us?
in the paraview picture there are some high pressure and low pressure points that should not be there.also in the outside of entrance.what does those mean?(I know this type of bad results may have a name i can't remember.whats that?)
is mesh bad?or schemes?
I have used a huge reservoir with a tiny tube attached to it with lower pressure than it as initial condition.

Attached Thumbnails

immortality June 2, 2013 02:05

this issue was solved the days after i asked.
It was due to high time step.lowering maxCo resolved in.

All times are GMT -4. The time now is 05:20.