|
[Sponsors] |
How to probes a line instead of a point when running? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 6, 2013, 13:00 |
How to probes a line instead of a point when running?
|
#1 |
Member
Jack
Join Date: Dec 2011
Posts: 94
Rep Power: 14 |
Hi All,
I would like to monitor variables on discrete points in a line, how can I do it conveniently? I know that I can probe many points in the line, is there any better solution? Many thanks! Ping |
|
May 6, 2013, 20:10 |
|
#2 |
Member
Jack
Join Date: Dec 2011
Posts: 94
Rep Power: 14 |
I would like to plot a "2D contour" graphs with x axis=time, y axis=channel height, and U as the contour variables. By doing this, I can find the U variation at all time and all channel height. I prefer 50+ points on the lines to produce smooth contour graphs, so ....
Ping |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] non-orthogonal faces and incorrect orientation? | nennbs | OpenFOAM Meshing & Mesh Conversion | 7 | April 17, 2013 06:42 |
[Gmsh] Conversion Error | nuovodna | OpenFOAM Meshing & Mesh Conversion | 14 | October 1, 2010 12:07 |
[blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 08:36 |
[Gmsh] Gmsh and samplesurface | touf | OpenFOAM Meshing & Mesh Conversion | 2 | December 10, 2007 03:27 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 15:00 |