 |
 |
 |
|
|
|
[Sponsors] | ||||
Is PostChannel giving rms values at a given time or averaging from the beginning ? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 8, 2013, 15:09
|
Is PostChannel giving rms values at a given time or averaging from the beginning ?
|
#1 |
|
New Member
Join Date: May 2013
Posts: 23
Rep Power: 12  |
Hello
 The question is in the title. I have read some threads about the postChannel utility but I can't figure out how it works  ..Is it a spatial average in (xz) plane at a given time or is it a time-average from the beginning of the simulation of the spatial average in (xz) plane ? Thanks a lot ! |
|
|
|
|
|
| Tags |
| channelfoam, postchannel, rms, spatial average, time average |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| AMI speed performance | danny123 | OpenFOAM | 21 | October 24, 2020 04:13 |
| mixerVesselAMI2D's mass is not balancing | sharonyue | OpenFOAM Running, Solving & CFD | 6 | June 10, 2013 09:34 |
| calculation stops after few time steps | sivakumar | OpenFOAM Running, Solving & CFD | 7 | March 17, 2013 06:37 |
| pisoFoam with k-epsilon turb blows up - Some questions | Heroic | OpenFOAM Running, Solving & CFD | 26 | December 17, 2012 03:34 |
| Full pipe 3D using icoFoam | cyberbrain | OpenFOAM | 4 | March 16, 2011 09:20 |
Linear Mode
