 |
 |
 |
|
|
|
[Sponsors] | ||||
January 28, 2014, 13:53
|
Problems with the sample utility (cloud)
|
#1 |
|
New Member
Join Date: Nov 2013
Posts: 2
Rep Power: 0  |
Hi all,
I try to use sample to get the data from my simulation. But when I run sample the only output I will get is for y=0 even though my sampleDict has points from y=0 to y=0.0102. If I modify the sampleDict that the points start with y=0.0001 it fails immediately. Attached the sampleDict and sampleData. The sampleDict is just a section of the original file because it is to large to upload the whole file. Thank you Last edited by Medu; January 29, 2014 at 10:02. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem with circle sampling type, of Sample utility | nik | OpenFOAM Post-Processing | 4 | May 29, 2017 05:27 |
| sample utility : not all the fields are sampled | cuba | OpenFOAM Post-Processing | 1 | May 6, 2013 06:50 |
| Sample utility problems | msrinath80 | OpenFOAM Running, Solving & CFD | 12 | December 21, 2012 05:51 |
| [Commercial meshers] Several problems with the mesh conversion utility when converting the meshes from Gridgen | su_junwei | OpenFOAM Meshing & Mesh Conversion | 2 | July 26, 2008 23:58 |
| Sample has problems with baffles propably problem with particletrackToFace | mattijs | OpenFOAM Bugs | 1 | October 22, 2007 09:20 |
Linear Mode
