|March 9, 2014, 04:51||
sample along a curved pipe wall
Join Date: Feb 2014
Posts: 5Rep Power: 5
i'm trying to get the pressure along a curved pipe wall.
for example if i have 3 points defining the curve (as in blockMeshDict - edge -arc setup) & when i try the simple sampleDict as below i get an error.
i've searched around but not found any real help.
works fine with straight lines.
is there a better way to get pressure, etc along a curved wall for plotting in excel.
// * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * //
points ((-1.0 0.0 0.0)
(-0.71 -0.71 0.0)
(0.00 1.0 0.0));
|March 19, 2014, 20:17||
try cloud type
Join Date: Jan 2014
Location: California, USA
Posts: 21Rep Power: 5
One of the options with the sample utility is to specify a series of points explicitly. This is the 'cloud' option. You can then extract values from each of your solutions at exactly those points using sample.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Wall normal grid configuration in pipe||hnemati||Main CFD Forum||1||January 7, 2014 09:52|
|Water subcooled boiling||Attesz||CFX||7||January 5, 2013 04:32|
|[ICEM] Export ICEM mesh to Gambit / Fluent||romekr||ANSYS Meshing & Geometry||1||November 26, 2011 13:11|
|UDF for wall slipping||HFLUENT||Fluent UDF and Scheme Programming||0||April 27, 2011 12:03|
|Axissymmetric pipe Simulation with unequal zero wall velocity||Thomas Baumann||OpenFOAM||6||July 15, 2009 04:36|