 |
 |
 |
|
|
|
[Sponsors] | ||||
September 28, 2015, 08:02
|
solidDisplacementFoam; strain tensor output
|
#1 |
|
New Member
muh hassani
Join Date: Sep 2015
Posts: 1
Rep Power: 0  |
Dear all,
I am trying to simulate a very simple case with the solidDisplacementFoam solver. In the outputs you can find Stress tensor and Displacment. But what I actually need is the strain tensor. I would like to know if there is a way so I can get the strain tensor as an output or post-processing calculation with foamCalc. I know I can just simple write a code to calculate the strain following the equation: "epsilon=0.5*(grad(U)+(grad(U))^T)". But I wonder it can be done simpler than this. best regards. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| shear rate and strain rate | Lilly | FLUENT | 1 | August 29, 2014 00:46 |
| Shear Strain Rate | Dave442 | Main CFD Forum | 5 | October 25, 2013 04:08 |
| UDF diffusivity (strain rate)-UDS | Lilly | Fluent UDF and Scheme Programming | 0 | September 6, 2013 02:47 |
| strain rate magnitude | ahmadbakri | STAR-CCM+ | 1 | June 3, 2010 13:03 |
| strain rate at arbitrary position in a cell | K. Kevala | FLUENT | 0 | February 4, 2004 17:14 |
Linear Mode
