|
[Sponsors] |
twoLiquidMixingFoam velocity residual monitor |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Taeyoung Kim
Join Date: Feb 2013
Posts: 4
Rep Power: 9 ![]() |
Hello,
I am in trouble in monitoring velocity residual through twoLquidMixingFoam with of30x. I searched some informations that I needed to change to momentumPredictor yes; in fvSolution/Pimple section to calculate velocity directly. twoLiquidmixingFoam is working well when momentumPredictor is set to no, but if yes, code is not working. If you have any experiences of this, I hope to hear it. Thank you Young |
|
![]() |
![]() |
![]() |
Tags |
residual, twoliquidmixingfoam, velocity |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Maximum number of iterations exceeded chtmultiregionsimpleFoam | Moncef | OpenFOAM Running, Solving & CFD | 28 | July 13, 2020 15:26 |
simpleFoam error - "Floating point exception" | mbcx4jc2 | OpenFOAM Running, Solving & CFD | 12 | August 4, 2015 03:20 |
Compressor Simulation using rhoPimpleDyMFoam | Jetfire | OpenFOAM Running, Solving & CFD | 107 | December 9, 2014 14:38 |
SixDoFRigidBodyMotion under OF2.3 ( self oscillating cylinder) | Scabbard | OpenFOAM Running, Solving & CFD | 1 | July 22, 2014 05:50 |
Problems with simulating TurbFOAM | barath.ezhilan | OpenFOAM | 13 | July 16, 2009 06:55 |