Stepping through cutting plane results using ParaFoam

alanaj5 · September 12, 2016, 05:39

Hi,

I was wondering if someone could help me.
I've completed an OpenFOAM simulation and have generated slices and isosurfaces. I'd like to view them and step through them in paraFoam. Currently they're all in separate folders corresponding to the relevant timesteps. A colleague of mine has managed it, but doesn't remember how. It looks to be a file extraction and renaming exercise such that,

/CuttingPlane/0/T_iso.vtk
/CuttingPlane/1/T_iso.vtk

become

/CuttingPlane/T_iso.vtk.0
/CuttingPlane/T_iso.vtk.1

Is it a renaming exercise? Is there a script out there for doing this?

Thanks for your help,
Siân

tomf · September 13, 2016, 03:34

Probably it is this script that was used:

Code:

foamSequenceVTKFiles

best regards,
Tom

September 12, 2016, 05:39	Stepping through cutting plane results using ParaFoam	#1
alanaj5 New Member Sian Join Date: Jun 2016 Posts: 5 Rep Power: 9	Hi, I was wondering if someone could help me. I've completed an OpenFOAM simulation and have generated slices and isosurfaces. I'd like to view them and step through them in paraFoam. Currently they're all in separate folders corresponding to the relevant timesteps. A colleague of mine has managed it, but doesn't remember how. It looks to be a file extraction and renaming exercise such that, /CuttingPlane/0/T_iso.vtk /CuttingPlane/1/T_iso.vtk become /CuttingPlane/T_iso.vtk.0 /CuttingPlane/T_iso.vtk.1 Is it a renaming exercise? Is there a script out there for doing this? Thanks for your help, Siân

September 13, 2016, 03:34		#2
tomf Senior Member Tom Fahner Join Date: Mar 2009 Location: Breda, Netherlands Posts: 634 Rep Power: 32	Probably it is this script that was used: Code: foamSequenceVTKFiles best regards, Tom bkay likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Gmsh] Problem with Gmsh	nishant_hull	OpenFOAM Meshing & Mesh Conversion	23	August 5, 2015 02:09
Plane stress and plane strain cases for stress analysis	Sargam05	OpenFOAM	0	May 3, 2013 18:16
[OpenFOAM] cutting plane	norkistar	ParaView	0	November 4, 2012 20:54
Flux through a cutting plane	olesen	OpenFOAM Post-Processing	1	November 4, 2008 02:15
Symmetry plane and force calculation	Roland	CFX	7	May 31, 2006 13:34