 |
 |
 |
|
|
|
[Sponsors] | ||||
November 24, 2016, 08:35
|
IDDES-yPlusRAS or yPlusLES?
|
#1 |
|
New Member
Join Date: Mar 2016
Posts: 29
Rep Power: 10  |
Hey,
I just finished an IDDES-Simulation. Now I wanted to check, if the wall resolved fine enough to get y+<1. Should I use yPlusRAS or yPlusLES? Or both of them? Thanks in advance for your help. |
|
|
|
|
|
December 1, 2016, 12:03
|
|
#2 |
|
New Member
Join Date: Mar 2016
Posts: 29
Rep Power: 10 |
Is my question so simple, that nobody answers?
The problem is, yPlusLES works fine, but yPlusRAS gives me an error: "cannot find file .../"timestep"/nut So I don't know if solving the yPlusRAS problem makes sense or will be just a waste of time. Thanks in advance for your answer 
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| IDDES in OF2.4 for Sphere on incompressible flow | aerospain | OpenFOAM Running, Solving & CFD | 0 | April 1, 2016 18:23 |
| yPlusRAS & yPlusLES doesn't work for multiphase Solvers (e.g. twoLiquidMixingFoam) | cfdonline2mohsen | OpenFOAM Post-Processing | 3 | July 20, 2014 13:30 |
| different values: yPlusLES functionObject - yPlusLES utility | aylalisa | OpenFOAM Post-Processing | 0 | June 10, 2014 08:57 |
| yPlusRAS used on SRF-case | Tobias Adam | OpenFOAM Post-Processing | 1 | April 7, 2014 08:09 |
| yPlusRAS in OF 1.6.x - Low Re Models | ivan_cozza | OpenFOAM Running, Solving & CFD | 0 | September 23, 2009 05:27 |
Linear Mode
