 |
 |
 |
|
|
|
[Sponsors] | ||||
April 12, 2018, 06:24
|
foamToVTK problem
|
#1 |
|
Member
Jung da yoon
Join Date: Nov 2017
Posts: 53
Rep Power: 8  |
Hello all!!
I run the multiregion heater radiation tutorial in chtmultiregionsimplefoam. I entered 'foamToVTK' to check the results in paraview. But I can't check the results. After I clicked the time play botton, I couldn't check the variables of result. What should i do? |
|
|
|
|
|
April 12, 2018, 12:03
|
Re: paraFoam -touchAll
|
#2 |
|
Senior Member
Charles
Join Date: Aug 2016
Location: Vancouver, Canada
Posts: 148
Rep Power: 9 |
You don't need to use foamToVTK. Just type "paraFoam -touchAll" in terminal, you will see a couple of new files. Open those files in paraFoam, you will get what you want.
|
|
|
|
|
|
|
April 13, 2018, 08:22
|
|
#3 |
|
Member
Jung da yoon
Join Date: Nov 2017
Posts: 53
Rep Power: 8 |
Hello
Thank you for replying!! But I have to use 'foamToVTK'. What should i do 
|
|
|
|
|
|
|
April 15, 2018, 10:39
|
|
#4 |
|
Senior Member
Charles
Join Date: Aug 2016
Location: Vancouver, Canada
Posts: 148
Rep Power: 9 |
You may use,
foamToVTK -region "[[your region name]]" |
|
|
|
|
|
|
April 15, 2018, 10:43
|
|
#5 |
|
Member
Jung da yoon
Join Date: Nov 2017
Posts: 53
Rep Power: 8 |
Thank you so much , marpole!!
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| area does not match neighbour by ... % -- possible face ordering problem | St.Pacholak | OpenFOAM | 10 | February 7, 2024 21:50 |
| UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 04:43 |
| natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
| Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
| Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 14:52 |
Linear Mode
