|
[Sponsors] |
October 14, 2017, 21:28 |
Outlet Surface 2D Data Collecting
|
#1 |
New Member
Join Date: Apr 2017
Posts: 2
Rep Power: 0 |
Hello Folks,
I have a very simple T shape microfluidic device that has 2 inlets and 1 outlet. I am simulating scalarTrasportFoam (3D) after I obtain velocity field. The purpose of this study is to determine mixing efficiency at the outlet. I have 2 simulations which are at Re 1 and 100. If you can help for the following questions I would be very happy. 1) Both passive scalar problem was run at Co=0.5, linearUpwindscheme, Tolerance for T 1e-10, ddt Euler; however, Re 100 solution is very oscillatory. (I copied both U and Phi, which were obtained from vel field, into the 0 folder of scalartransportfoam cases) 2) I am trying to get T data at the outlet as 2D. I mean, I want to divide height and width of my outlet crossection for a certain points and I am trying to obtain these data, yet I could not succeed using both paraview and controldict. Is there any way to obtain data as shown below. OUTLET Width = Divide 200 Height = Divide 100 Point 1 = T(X1,Y1) Point 2 = T(X1,Y2) ... Point ... = T(X...,Y...) Total Points will be 20000 I really appreciate in advance for all your helps! |
|
Tags |
2d data collecting |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDF for transient pressure outlet boundary from data array | nathanblank | FLUENT | 1 | June 1, 2015 04:09 |
[Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 13:43 |
Interpolating volume data onto quad surface mesh | N.R. | CFX | 6 | June 7, 2007 09:15 |
accessing sover data for surface deposition rate | Ashish Jain | FLUENT | 0 | June 4, 2005 04:39 |