Reassemble files after -postProcess -- CFD Online Discussion Forums

July 2, 2020, 08:53

Reassemble files after -postProcess

filippo222

New Member

fpp prr

Join Date: Jun 2020

Posts: 3

Rep Power: 5

Hi everybody, I'm running simulations with pimpleDyMFoam with parallelization, after the simulation I wanted to re-run only the postProcessing using pimpleDyMFoam -postProcess, everything went ok but it saved all the force files in separated folders (picture attached), is there a way to reassemble everithing in an unique file?
Thanks

Attached Images

Cattura.jpg (201.3 KB, 7 views)

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
problem compiling with header files	jreiter164	Fluent UDF and Scheme Programming	2	August 14, 2015 17:31
attaching trn files	hossein_sml	CFX	1	August 5, 2015 19:17
How to call FORTRAN files as UDF?	Ehsan-F	Fluent UDF and Scheme Programming	6	September 11, 2012 11:03
Writing Case and Data Files Using Journal/Scheme Files	svp	Fluent UDF and Scheme Programming	0	April 5, 2011 11:04
Problems with result files	Kasper	CFX	5	December 14, 2006 02:41

All times are GMT -4. The time now is 07:15.