 |
 |
 |
|
|
|
[Sponsors] | ||||
How to get the cartesian coordinates using icoUncoupledKinematicParcelFoam |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 6, 2020, 03:43
|
How to get the cartesian coordinates using icoUncoupledKinematicParcelFoam
|
#1 |
|
New Member
Lucie Recurt
Join Date: Jun 2020
Posts: 17
Rep Power: 6  |
Hello everyone!
 I'm currently trying to track particle using the solver icoUncoupledKinematicParcelFoam of OpenFoam 7. My simulation runs well  but the only positions for the particles that I get are barycentric coordinates. And I didn't find on Internet an easy method to switch barycentric coordinates to cartesian's ones...  I was wondering if there is a way in OpenFoam 7 to print the cartesian coordinates? Or to print the trajectory of particles?  Thanks to all in advance, hope someone know how to do that... 
|
|
|
|
|
|
| Tags |
| barycentric, cartesian, coordinate, openfoam, trajectory |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Difficulty In Setting Boundary Conditions | Moinul Haque | CFX | 4 | November 25, 2014 17:30 |
| LES in DES can't be actived! | shenying0710 | CFX | 17 | January 23, 2014 04:45 |
| [mesh manipulation] Mapping mesh from cartesian coordinates to cylindrical coordinates | matteo_pellegri | OpenFOAM Meshing & Mesh Conversion | 0 | December 10, 2013 10:31 |
| Conversion of Toroidal Coordinates to Cartesian Coordinates | go2saqi | Main CFD Forum | 0 | May 8, 2013 02:51 |
| [ICEM] Exporting Cartesian coordinates from ICEM to Matlab? | user_of_cfx | ANSYS Meshing & Geometry | 0 | October 17, 2011 10:17 |
Linear Mode
