|
[Sponsors] |
September 11, 2020, 21:36 |
ParaView does not open data
|
#1 |
New Member
Brock
Join Date: Sep 2020
Posts: 2
Rep Power: 0 |
Hi everyone!
I'm pretty new to OpenFoam and paraview, and I got everything I needed installed and everything appears to work fine, except I run into an issue when launching ParaView with the 'paraFoam' command. I'm running Windows 10, and I followed this guide exactly: https://openfoam.org/download/windows-10/ So I'm running a linux shell with UBUNTU 18.04 LTS. I tried a very basic tutorial to see if my install was working properly: https://cfd.direct/openfoam/user-gui...ty/#x5-40002.1 But when I launch paraview with the command 'paraFoam', I get the following readout: Created temporary 'cavity.OpenFOAM' QStandardPaths: XDG_RUNTIME_DIR not set, defaulting to '/tmp/runtime-[user]' failed to get the current screen resources I/O : uncollated Paraview opens and will display the model, but the data doesn't load in. I've been trying to figure this out for the past few days, but unfortunately I'm not the most computer savvy. Any help would be greatly appreciated! |
|
September 17, 2020, 15:34 |
|
#2 |
New Member
Ra Miro
Join Date: Aug 2020
Posts: 21
Rep Power: 5 |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[swak4Foam] swak4foam for OpenFOAM 4.0 | mnikku | OpenFOAM Community Contributions | 80 | May 17, 2022 08:06 |
[OpenFOAM.org] Error creating ParaView-4.1.0 OpenFOAM 2.3.0 | tlcoons | OpenFOAM Installation | 13 | April 20, 2016 17:34 |
OpenFOAM without MPI | kokizzu | OpenFOAM Installation | 4 | May 26, 2014 09:17 |
centOS 5.6 : paraFoam not working | yossi | OpenFOAM Installation | 2 | October 9, 2013 01:41 |
How to update polyPatchbs localPoints | liu | OpenFOAM Running, Solving & CFD | 6 | December 30, 2005 17:27 |