Postprocessing average Temperature in a specific direction -- CFD Online Discussion Forums

August 27, 2022, 15:02

Postprocessing average Temperature in a specific direction

davcrisp

New Member

Christian Pinzón

Join Date: Apr 2022

Posts: 6

Rep Power: 4

I want to calculate the average Temperature in the "x" direction in a flat parallel plane, to the plane showed in figure 1, when the simulation is over. But I have no idea how I can create a parallel plane in the downstream part and then calculate the average in the cross section. Could you give me any advice to solve that? Thanks

Attached Images

	flatplate.png (4.3 KB, 3 views)
	fullDomain.png (14.9 KB, 4 views)

Tags

average temperature, flat plate, mean temperature

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Setting the height of the stream in the free channel	kevinmccartin	CFX	12	October 13, 2022 21:43
Ansys Fluent UDF, Wall Average Temperature Depend On Inlet Velocity	ozgeozge	Fluent UDF and Scheme Programming	1	April 15, 2019 01:31
Multiphase flow - incorrect velocity on inlet	Mike_Tom	CFX	6	September 29, 2016 01:27
Calculation of the Governing Equations	Mihail	CFX	7	September 7, 2014 06:27
Two-Phase Buoyant Flow Issue	Miguel Baritto	CFX	4	August 31, 2006 12:02

All times are GMT -4. The time now is 11:40.