[nicasch]

Dear all,
I run a damBreakWithObstacle tutorial with automatic mesh refinement. I was able to run it in parallel.
During the first run I stopped it after a while and could not reconstruct the case. I obtained the following message:

...

Create time

Create mesh for time = 0

Time = 0

Reconstructing FV fields

Reconstructing volScalarFields

pd
gamma
gamma.org

Reconstructing volVectorFields

U

No point fields

No lagrangian fields

Time = 0.00815822



cannot open file

file: /home/eberberovic/OpenFOAM/eberberovic-1.5/run/damBreakWithObstacle/processor0/0 .00815822/polyMesh/pointProcAddressing at line 0.

From function regIOobject::readStream(const word&)
in file db/regIOobject/regIOobjectRead.C at line 66.

FOAM exiting


Then I run the case again until the end time. Running was OK. But reconstruction did not work, I obtained the same error as before.

Any idea why this happens?

Thanks and regards.

[mattijs]

Your mesh has changed. So you cannot just reconstruct the fields onto the original mesh (which is what reconstructPar does). Have a search for 'reconstructParMesh' on this forum.