|
[Sponsors] |
August 21, 2008, 11:48 |
Hi Everybody,
I just disco
|
#1 |
Senior Member
Frank Bos
Join Date: Mar 2009
Location: The Netherlands
Posts: 340
Rep Power: 18 |
Hi Everybody,
I just discovered the use of sampleSurface on a moving wall, for example a 3D wing. All moving coordinates and pressure are written to one file. Right now, I am trying to do the following: Write the pressure on the moving wall AT certain planes....So is there a way to use patches AND planes in this sampleSurface utility? In such a way we can plot i.e. Cp along the chord at different spanwise locations. Thanks, Frank
__________________
Frank Bos |
|
August 21, 2008, 16:08 |
There is nothing in sampleSurf
|
#2 |
Senior Member
Mattijs Janssens
Join Date: Mar 2009
Posts: 1,419
Rep Power: 26 |
There is nothing in sampleSurface. Guess you'll have to do the re-sampling in paraview.
|
|
April 19, 2013, 11:42 |
|
#3 | |
New Member
Teng Wu
Join Date: Feb 2012
Posts: 9
Rep Power: 14 |
Quote:
I'm wondering whether you have find the solution on this issue? Recently I'm also struggling with the same issue but cannot get a good solution! Thanks, Teng Wu |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
SampleSurface problem | saf5029 | OpenFOAM Post-Processing | 2 | June 13, 2008 14:42 |
[Gmsh] Gmsh and samplesurface | touf | OpenFOAM Meshing & Mesh Conversion | 2 | December 10, 2007 02:27 |
SurfaceWriters other than raw are not selectable in sampleSurface | hannes | OpenFOAM Bugs | 4 | August 28, 2007 09:04 |
[OpenFOAM] Question about sampleSurface | osimonsimon | ParaView | 0 | October 16, 2006 22:32 |
[OpenFOAM] Zero values using sampleSurface | steja | ParaView | 2 | June 15, 2006 04:23 |