Hi Guys: I have a question
 

Hi Guys:

I have a question about tecplot. I got some 3D flow fields using icoFoam and converted all to tecplot format using foamtotecplot. I was able to read data in tecplot and it looks all right. The problem is that the vector plots were too crowdy. So I tried to adjust vector density by index skipping. Only a single I-ordered zone was activated. I went throught the tecplot manual and it basically says that this is because the data set is unorganized. Anybody here has any thoughts on that? How to organize the data set? Thank you.

Ning

I have foamToTecplot but I d o
 

I have foamToTecplot but I d ont know how use it ? somebody can help me ?

thank you