 |
 |
 |
|
|
|
[Sponsors] | ||||
March 15, 2010, 15:33
|
foamLog reading a vector
|
#1 |
|
New Member
Ruben Paredes
Join Date: Mar 2009
Location: Guayaquil, Ecuador
Posts: 20
Rep Power: 17   |
Hello,
I am writing in the log file the position and velocity of the center of gravity as a vector. I would like to know if there is a way to modify the foamLog script to read these values. I added some lines in the foamLog.db file #- Center of mass CG_Position/Centre of mass:/( But the script is only reading the first component of the vector. I am new to linux, any idea? R. |
|
|
|
|
|
May 27, 2010, 15:43
|
|
#2 |
|
Senior Member
Pierre-Olivier Dallaire
Join Date: Mar 2009
Location: Montreal, Quebec, Canada
Posts: 192
Rep Power: 17 |
Hi !
Just wondering if you found the way to do that. Regards, PO |
|
|
|
|
|
|
May 27, 2010, 23:25
|
|
#3 |
|
New Member
Ruben Paredes
Join Date: Mar 2009
Location: Guayaquil, Ecuador
Posts: 20
Rep Power: 17 |
I wrote a script that extracts CG position in log file and save it in a text file
__________________
R. |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Commercial meshers] Problem converting fluent mesh | vinz | OpenFOAM Meshing & Mesh Conversion | 28 | October 12, 2015 06:37 |
| [Commercial meshers] Converting a mesh with splitted cells using fluentMeshToFoam | jlpelerin | OpenFOAM Meshing & Mesh Conversion | 4 | April 25, 2011 16:56 |
| problem when converting mesh (made by ICEM) using fluentMeshToFoam | Forrest_Lei | OpenFOAM | 11 | October 16, 2009 06:28 |
| [Commercial meshers] TGridFluent mesh with internal by prism layer and internal face for diagnostic | sponiar | OpenFOAM Meshing & Mesh Conversion | 2 | March 30, 2009 15:02 |
| [Commercial meshers] FluentMesh conversion problem | waynezw0618 | OpenFOAM Meshing & Mesh Conversion | 12 | November 30, 2006 23:12 |
Linear Mode
