|April 1, 2010, 08:42||
Boundary Layer separation
Join Date: Nov 2009
Posts: 93Rep Power: 9
I'm working on a case @Re=40 000, I resolve the boundary layer and I would like to see its separation.
How can I do that in ParaFoam? Apparently, best way to see that is to look at the streamlines and see where they detached from the wall.
But in parafoam, even if I put a huge number of points in the streamline tool : Either it crashes or either it's not precise enough
Does anyone suceed in visualising separation point?
Thanks for the help
|Thread||Thread Starter||Forum||Replies||Last Post|
|Wind turbine simulation||Saturn||CFX||45||February 8, 2016 05:42|
|Combining BCs: wall - outlet. Boundary layer disappears||MartinaF||OpenFOAM Running, Solving & CFD||1||July 20, 2009 18:14|
|CREATION OF BOUNDARY LAYER||Jibran Haider||FLUENT||3||August 1, 2008 00:33|
|Convective Heat Transfer - Heat Exchanger||Mark||CFX||6||November 15, 2004 16:55|
|New topic on same subject - Flow around race car||Tudor Miron||CFX||15||April 2, 2004 06:18|