|
[Sponsors] |
May 30, 2014, 17:33 |
Data manipulation
|
#1 |
New Member
Ian Dizon
Join Date: May 2014
Posts: 6
Rep Power: 11 |
Hello everyone,
I am trying to plot dimensionless temperature vs a height ratio at the center of my 2D mesh. I want both the height ratio and dimensionless temperature to be between 0 and 1. To do this I need to define a term, theta, which is calculated from temperature. theta=(T - Tmin) / (Tmax - Tmin) where T has been solved for, and Tmin and Tmax are constants. I'm thinking I should use foamCalc for this but am unsure. If anyone can help that would be great! Thank you, Ian |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Writing/output of simple data into an ASCII-File | matthi | OpenFOAM Programming & Development | 24 | January 8, 2019 13:28 |
[OpenFOAM] saving data in paraview | aylalisa | ParaView | 3 | May 31, 2014 11:38 |
IFStream read float point data problem | liu | OpenFOAM Running, Solving & CFD | 0 | October 24, 2008 12:14 |
How to update polyPatchbs localPoints | liu | OpenFOAM Running, Solving & CFD | 6 | December 30, 2005 17:27 |
CFXSolver Error Message using Profile Data on B | Tobias | CFX | 0 | August 26, 2005 07:27 |