 |
 |
 |
|
|
|
[Sponsors] | ||||
September 14, 2010, 10:56
|
normal wall stress
|
#1 |
|
Member
Nico T
Join Date: Aug 2010
Location: Leipzig, Germany
Posts: 39
Rep Power: 15  |
Hello,
I guess this is a frequently asked question: How can I calculate the normal stress of a wall? I used stressComponents, but this provides only sigmaxx, xy, yy.... Btw: The values of sigmaxx etc. seem to be very small for my case: 1e-6 mē/sē = 1e-3 Pa (with rho= 1000). I would expect values of at least 100 Pa. Did I understood / calculated sth. wrong? Thanks for help, Nico |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to get the wall shear stress by UDF | Chen Fangzhi | FLUENT | 3 | November 11, 2014 06:03 |
| Unit normal vector of nearest wall | l_r_mcglashan | OpenFOAM Programming & Development | 3 | May 13, 2014 17:06 |
| how to set up a wall boundary condition according to calculated wall shear stress? | gameoverli | OpenFOAM Pre-Processing | 1 | May 21, 2009 08:28 |
| Specifying shear stress on wall in 5.5.1 | michael rasmussen | CFX | 1 | May 19, 2003 09:49 |
| X-Y plot of Yplus in Fluent 5.3 | Luo | FLUENT | 24 | April 11, 2000 06:07 |
Linear Mode
