CFD Online Discussion Forums

CFD Online Discussion Forums (
-   OpenFOAM Post-Processing (
-   -   Non-zero wall velocity using foamToTecplot360 (

elbertj October 11, 2010 18:45

Non-zero wall velocity using foamToTecplot360
Dear Foamers,
When I use foamToTecplot360 and post-process in Tecplot I observe wall velocities to be non-zero. The boundaryMesh plt file has it right. Does the volume data plt contain data one cell away from wall or is it missing a ghost cell?
Kindly let me know.


anijdon December 14, 2010 17:24

hi Elbert.
I hope to your problem was resolved.
excuse me,I have an intermediat quistion.I don't know how I can convert foam data to tecplot360?which utility should I use?

All times are GMT -4. The time now is 17:56.