Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Pre-Processing

how to set concentric cylinder zones by cellZone option?

Updated Threads

Reply

Search this Thread

September 27, 2012, 11:26	how to set concentric cylinder zones by cellZone option?	#1
sachinlb Member Dr Sachin Borse Join Date: Oct 2011 Location: Pune, Republic of India Posts: 52 Rep Power: 14	Dear All, I wish to make different annular cell zones in cylinder domain. how to set concentric cylinder zones by cellZone option? Regards Dr Borse

September 28, 2012, 03:20		#2
ngj Senior Member Niels Gjoel Jacobsen Join Date: Mar 2009 Location: Copenhagen, Denmark Posts: 1,900 Rep Power: 37	Good morning Sachin, One option is to make an stl surface begin a cylinder of finite wall thickness. Kind regards, Niels

Reply

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind turbine simulation	Saturn	CFX	58	July 3, 2020 01:13
Simulation of a single bubble with a VOF-method	Suzzn	CFX	21	January 29, 2018 00:58
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 04:05
increasing mesh quality is leading to poor convergence	tippo	CFX	2	May 5, 2009 10:55

All times are GMT -4. The time now is 09:34.