CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   OpenFOAM Pre-Processing (https://www.cfd-online.com/Forums/openfoam-pre-processing/)
-   -   how to set concentric cylinder zones by cellZone option? (https://www.cfd-online.com/Forums/openfoam-pre-processing/107457-how-set-concentric-cylinder-zones-cellzone-option.html)

sachinlb September 27, 2012 11:26
how to set concentric cylinder zones by cellZone option?
 
Dear All,
I wish to make different annular cell zones in cylinder domain. how to set concentric cylinder zones by cellZone option?
Regards
Dr Borse

ngj September 28, 2012 03:20
Good morning Sachin,

One option is to make an stl surface begin a cylinder of finite wall thickness.

Kind regards,

Niels


All times are GMT -4. The time now is 02:17.