 |
 |
 |
|
|
|
[Sponsors] | ||||
October 2, 2012, 05:07
|
Finned heat exchanger
|
#1 |
|
Member
ankur
Join Date: May 2012
Location: India
Posts: 50
Rep Power: 13  |
I am designing a finned air cooled heat exchanger, It has around 24 tubes of 2 m length each, the fin density is around 200 fins/m. I want to perform the CFD simulation of it, but my problem is how to make the geometry with the fins in any software, can anyone please help me and can tell me which software is good for this purpose.
Thanks Ankur |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Heat Exchanger Model | sak2129 | FLUENT | 3 | September 26, 2017 01:29 |
| How to carry out 3D shell and Tube Heat Exchanger analysis in fluent | medogalal | FLUENT | 3 | December 30, 2015 04:28 |
| Macro Heat Exchanger not selecting (Please help!) | zdeth | FLUENT | 2 | September 11, 2012 13:52 |
| UDF for Heat Exchanger model | francois louw | FLUENT | 2 | July 16, 2010 02:21 |
| Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Linear Mode
