CFD Online Discussion Forums

CFD Online Discussion Forums (
-   OpenFOAM Pre-Processing (
-   -   manual decomposePar (

ganeshv December 11, 2012 15:39

manual decomposePar
hi !

I have two meshes. I am running the simulations in mesh1. I now need to decompose mesh2 such that the bits of mesh2 and mesh1 overlap on each processor. Does anyone have a useful tool for this? Ideally I would like to label each cell on mesh2 with the appropriate processorID and then use decomposePar.

On a related note, is there an easy way to get the cellDist information on an already decomposed mesh? Say using funkySetFields or other?


All times are GMT -4. The time now is 11:47.