|
[Sponsors] |
are these values for turbulency that I put true? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 18, 2013, 13:21 |
are these values for turbulency that I put true?
|
#1 |
Senior Member
Ehsan
Join Date: Oct 2012
Location: Iran
Posts: 2,208
Rep Power: 26 |
this is a tank with different internalField values.
have i set the values for k and omega correctly? --------------------------- should i set an internalField value for k and omega while the flow starting from rest?
__________________
Injustice Anywhere is a Threat for Justice Everywhere.Martin Luther King. To Be or Not To Be,Thats the Question! The Only Stupid Question Is the One that Goes Unasked. Last edited by immortality; May 18, 2013 at 15:17. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Jump in epsilon values near the wall : low re k-epsilon model | malaboss | OpenFOAM Verification & Validation | 1 | February 1, 2013 16:36 |
Cd values for 3D rectangular cylinder | karthik | FLUENT | 1 | August 28, 2009 06:32 |
Printing Values on a Specific Surface | Matthew | FLUENT | 1 | February 8, 2006 08:15 |
CFD VALUES AT EXPERIMENTAL POINT | J | FLUENT | 1 | September 25, 2005 16:55 |
Y+ Values for a sperating flow over a hill | Dave | FLUENT | 2 | July 9, 2005 23:18 |